How do you set up a Catalyst 2960 switch?

Follow these steps:

  1. Connect the supplied RJ-45-to DB-9 adapter cable to the 9-pin serial port on the PC. Connect the other end of the cable to the console port on the switch.
  2. a. Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
  3. a.

How do you configure a basic switch?

How to configure a network switch

  1. Step 1: Connect to the console.
  2. Step 2: Set a management IP and default gateway.
  3. Step 3: Set hostname and domain name.
  4. Step 4: Set logins on VTY lines and console port.
  5. Step 5: Set Privileged EXEC password.
  6. Step 6: Enable SSH.
  7. Step 7: Create VLANs.
  8. Step 8: Add access ports to a VLAN.

How do I configure a Cisco syslog switch?

How to Configure Syslog on a Cisco Device

  1. Step 1: Enable logging on the Cisco device.
  2. Step 2: Modify the syslog config for facility codes.
  3. Step 3: Change the default logging levels.
  4. Step 4: Define destination port and IP address.
  5. Step 5: Define source IP address.
  6. Step 6: Securing syslog messages on a Cisco device (Optional)

Do I need to configure my switch?

Most switches used by small businesses and home offices typically require no configuration — they’re “plug and play.” However, it’s important to remember that plug and play doesn’t always work. In addition, these switches certainly don’t offer any troubleshooting, logging, security, or manageability.

How to show the uptime on a Cisco Catalyst 2950?

On the Gigabit Ethernet 1 interface,DHCP snooping is enabled on VLANs 10 to 20.

  • The Gigabit Ethernet 2 interface is configured as trusted for DHCP snooping.
  • On the Gigabit Ethernet 3 interface,DHCP snooping is not enabled on the VLANs to which the interface belongs.

    • How to crack Cisco switch password for catalyst 2950?

    Bits per second (baud): 9600

  • Data bits: 8
  • Parity: None
  • Stop bits: 1
  • Flow Control: Xon/Xoff

    • How to configure VLAN on Cisco 2950?

    Enter global configuration mode by issuing the configure terminal command.

  • Enter interface configuration mode,and issue the interface[type]< mod/port > command in order to enter the port to be added to the VLAN.
  • Issue the switchport mode trunk command in order to configure the port as a VLAN trunk.

    • How to manage Cisco 2950 switches by IP address?

    2950 switch – management ip. Hi, I have setup the switch below via the console port, with 3 vlans on it, port 1 is a trunk, port 2-4 vlan 2, port 5-11 vlan 3, port 12 vlan 1. I have setup up an ip address on interface vlan1 for the switch so that i can manage it.

    By Common questions